This training gives instructions on use of the Narda personal radiation alarm. This device is used when working around radiation hazards such as radars and high powered transmitters.
Method: |
Blended |
Duration: | 4 minutes |
Assessment: | None |
Help: | Contact your Lecturer |
- Teacher: Rob Duthie
- Teacher: Maria Fisher
- Teacher: Dane Greenfield
In this training the OHS document "Procedure For Working Safely With Electricity" is broken up into a 6 part
video series. As the videos progress through the document, key points are extracted and covered as they bring
across the intent of the document which is to make sure that the Bureau is a safe place to work and that every
worker when working with electricity does so in a safe and competent manner.
Method: |
Blended |
Duration: | Approx 90 minutes. The course uses a series of videos that dive deep into the OHS procedure. |
Assessment: | There is a quiz after each section and a final quiz for assessment. |
Help: | Contact the BMTC Electronic Technical Trainers |
- Teacher: Rob Duthie
- Teacher: Maria Fisher
- Teacher: Ben Gillson
- Teacher: Dane Greenfield
- Teacher: Brian McKechnie
To provide a process for the safe isolation of energy sources to reduce the risk of injury while equipment is being
inspected, repaired, replaced, maintained, assessed, adjusted, constructed or cleaned.
This training walks through the Occupational Health and Safety "Lockout Tagout Isolation Procedure".
The document is present through interactive web pages and a short practical video.
The Permit to Work for Bureau Workers and Contractors are also introduced as is the use of a digital signature to
aid in the management of these particular PDF documents.
Method: |
Blended |
Duration: | 45 - 90 minutes. Including videos and web pages and quizzes. |
Assessment: | There is a quiz after each section and a final quiz for assessment. |
Help: | Contact the BMTC Electronic Technical Trainiers. |
- Teacher: Rob Duthie
- Teacher: Dane Greenfield
- Teacher: Brian McKechnie